12 material differences
Tractor oneDeutz-Fahr Agroplus S 702005–2007No measured PTO figureTractor twoVALMET 44001993–1996No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (2005–2007; 1993–1996). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
12 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | Agroplus S 70 | 4400 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 66.4 hp | 66.1 hp | — |
| Engine declared | Lamborghini 1000.3 WT | VALMET 320 DS | differs |
| Displacement declared | 3.00 L | 3.30 L | +10% 4400 |
| Maximum torque declared | 192 lb·ft · 260 N·m | 177 lb·ft · 240 N·m | +8% Agroplus S 70 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6 mph · 30 km/h | +33% Agroplus S 70 |
| Clutch declared | — | Dry double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 14.3 gpm · 54.0 L/min | 10.3 gpm · 39.0 L/min | +38% Agroplus S 70 |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540/540E/1000 rpm | 540E/540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,456 lb · 2,475 kg | 6,151 lb · 2,790 kg | +13% 4400 |
| Wheelbase declared | 75.8 in · 1,926 mm | 83.1 in · 2,112 mm | +10% 4400 |
| Length declared | 140.8 in · 3,576 mm | 149.2 in · 3,790 mm | +6% 4400 |
| Width declared | 59.1–76.0 in · 1,500–1,930 mm | 80.0 in · 2,032 mm | differs |
| Ground clearance declared | 10.2 in · 260 mm | 19.9 in · 505 mm | +94% 4400 |
| Turning radius, braked declared | — | 12.8 ft · 3.90 m | — |
| Fuel tank declared | 58.1 qt · 55 L | 100.4 qt · 95.0 L | +73% 4400 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus S 70 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 70”
VALMET 4400 sources
- Source: Traktorenlexikon, “Valmet 4400”
- Source: Traktorenlexikon, “Valmet 465”