0 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus S 420from 2009No measured PTO figureTractor twoDeutz-Fahr Agroplus V 420from 2009No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their power is identical, with the same weight or the same engine, which usually means one machine sold under two names; any difference below comes from how each source describes it. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
0 material differences · 11 fields identical or within 5%, which is not counted as material
| Field | Agroplus S 420 | Agroplus V 420 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 94.7 hp | 94.7 hp | — |
| Engine declared | Same 1000.4 WT | Same 1000.4 WT | — |
| Displacement declared | 4.00 L | 4.00 L | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Hydraulic control declared | Constant flow | — | — |
| Pump flow declared | 14.3 gpm · 54.0 L/min | 14.3 gpm · 54.0 L/min | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm / 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,798 lb · 2,630 kg | 5,798 lb · 2,630 kg | — |
| Wheelbase declared | 80.9 in · 2,056 mm | 80.9 in · 2,056 mm | — |
| Length declared | 145.9 in · 3,706 mm | 145.9 in · 3,706 mm | — |
| Ground clearance declared | 11.0 in · 280 mm | 11.0 in · 280 mm | — |
| Fuel tank declared | 58.1 qt · 55 L | 58.1 qt · 55 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus S 420 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 420”
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 410”
Deutz-Fahr Agroplus V 420 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus V 420”
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 410”