10 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus F 420from 2009No measured PTO figureTractor twoNew Holland T 50502008–2012No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (35%); the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Agroplus F 420 | T 5050 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 94.7 hp | 95.6 hp | — |
| Engine declared | Same 1000.4 WT | IVECO-NEF F4CE 9484 M | differs |
| Displacement declared | 4.00 L | 4.49 L | +12% T 5050 |
| Maximum torque declared | — | 309 lb·ft · 419 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | electrohydraulically operated wet multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 14.3 gpm · 54.0 L/min | 17.5 gpm · 66.1 L/min | +22% T 5050 |
| Pressure declared | — | 3,336 psi · 230 bar | — |
| Rear PTO speeds declared | 540/540E/1000 rpm | 540/540E/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,041 lb · 2,740 kg | 8,168 lb · 3,705 kg | +35% T 5050 |
| Maximum permissible mass declared | — | 14,991 lb · 6,800 kg | — |
| Wheelbase declared | 81.5 in · 2,070 mm | 92.2 in · 2,342 mm | +13% T 5050 |
| Length declared | 148.2 in · 3,765 mm | 158.7 in · 4,030 mm | +7% T 5050 |
| Width declared | 53.9–78.1 in · 1,370–1,985 mm | 78.9 in · 2,005 mm | differs |
| Ground clearance declared | 9.4 in · 238 mm | 19.2 in · 488 mm | +105% T 5050 |
| Fuel tank declared | 47.6 qt · 45 L | 134.2 qt · 127.0 L | +182% T 5050 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus F 420 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus F 420”
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 410”
New Holland T 5050 sources
- Source: Traktorenlexikon, “New Holland T5050”