10 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus F 420from 2009No measured PTO figureTractor twoNew Holland T-40502008–2014No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (37%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Agroplus F 420 | T-4050 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 94.7 hp | 95.6 hp | — |
| Engine declared | Same 1000.4 WT | IVECO F4 CE 9484 M (Tier-III) | differs |
| Displacement declared | 4.00 L | 4.49 L | +12% T-4050 |
| Maximum torque declared | — | 305 lb·ft · 413 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 14.3 gpm · 54.0 L/min | 16.9 gpm · 63.8 L/min | +18% T-4050 |
| Pressure declared | — | 3,263 psi · 225 bar | — |
| Rear PTO speeds declared | 540/540E/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,041 lb · 2,740 kg | 8,289 lb · 3,760 kg | +37% T-4050 |
| Maximum permissible mass declared | — | 11,574 lb · 5,250 kg | — |
| Wheelbase declared | 81.5 in · 2,070 mm | 86.0 in · 2,185 mm | +6% T-4050 |
| Length declared | 148.2 in · 3,765 mm | 140.9 in · 3,580 mm | — |
| Width declared | 53.9–78.1 in · 1,370–1,985 mm | 73.5–95.6 in · 1,867–2,428 mm | differs |
| Ground clearance declared | 9.4 in · 238 mm | 15.0 in · 380 mm | +60% T-4050 |
| Fuel tank declared | 47.6 qt · 45 L | 93.0 qt · 88.0 L | +96% T-4050 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus F 420 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus F 420”
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 410”
New Holland T-4050 sources
- Source: Traktorenlexikon, “New Holland T 4050”