11 material differences · fewer than 12

Tractor oneDeutz-Fahr Agroplus F 420from 2009No measured PTO figureTractor twoDeutz-Fahr Agrotron 4.951995–1997No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (54%); they were not built in overlapping years (2009–2009; 1995–1997). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

11 material differences · 2 fields identical or within 5%, which is not counted as material

Deutz-Fahr Agroplus F 420 and Deutz-Fahr Agrotron 4.95, field by field
FieldAgroplus F 420Agrotron 4.95Gap
Engine
Engine power, claimed claimed94.7 hp94.9 hp—
Engine declaredSame 1000.4 WTDeutz BF4M 1012 ECdiffers
Displacement declared4.00 L3.19 L+25% Agroplus F 420
Maximum torque declared—263 lb·ft · 356 N·m—
Transmission
Top speed declared24.9 mph · 40 km/h18.6–24.9 mph · 30–40 km/hdiffers
Hydraulics & hitch
Hydraulic centre declaredOpen centreOpen centre—
Pump flow declared14.3 gpm · 54.0 L/min17.0 gpm · 64.5 L/min+19% Agrotron 4.95
Pressure declared—2,901 psi · 200 bar—
Rear PTO speeds declared540/540E/1000 rpm540/1000 rpmdiffers
Weight & dimensions
Unladen weight declared6,041 lb · 2,740 kg9,304 lb · 4,220 kg+54% Agrotron 4.95
Maximum permissible mass declared—16,535 lb · 7,500 kg—
Wheelbase declared81.5 in · 2,070 mm95.2 in · 2,419 mm+17% Agrotron 4.95
Length declared148.2 in · 3,765 mm157.7 in · 4,005 mm+6% Agrotron 4.95
Width declared53.9–78.1 in · 1,370–1,985 mm79.1 in · 2,008 mmdiffers
Ground clearance declared9.4 in · 238 mm19.1 in · 485 mm+104% Agrotron 4.95
Fuel tank declared47.6 qt · 45 L190.2 qt · 180 L+300% Agrotron 4.95

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr Agroplus F 420 sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agroplus F 420”
  • Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 410”

Deutz-Fahr Agrotron 4.95 sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agrotron 4.95”
  • Source: Traktorenlexikon, “Deutz-Fahr Agrotron 100”