7 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus 410from 2009No measured PTO figureTractor twoDeutz-Fahr Agroplus V 410from 2009No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (30%); the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Agroplus 410 | Agroplus V 410 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 83.8 hp | 83.8 hp | — |
| Engine declared | Same 1000.4 WTI 2 E3 | Same 1000.4 WT | differs |
| Displacement declared | 4.00 L | 4.00 L | — |
| Maximum torque declared | 254 lb·ft · 345 N·m | — | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Clutch declared | Hydraulically operated single-plate dry clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.8 gpm · 41.0 L/min | 14.3 gpm · 54.0 L/min | +32% Agroplus V 410 |
| Rear PTO speeds declared | 540/540E/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,518 lb · 3,410 kg | 5,798 lb · 2,630 kg | +30% Agroplus 410 |
| Wheelbase declared | 87.8 in · 2,230 mm | 80.9 in · 2,056 mm | +8% Agroplus 410 |
| Length declared | 140.2 in · 3,560 mm | 145.9 in · 3,706 mm | — |
| Width declared | 81.5–91.7 in · 2,070–2,330 mm | — | — |
| Ground clearance declared | 15.4 in · 390 mm | 9.8 in · 250 mm | +56% Agroplus 410 |
| Turning radius, braked declared | 12.8 ft · 3.90 m | — | — |
| Fuel tank declared | 95.1 qt · 90 L | 58.1 qt · 55 L | +64% Agroplus 410 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus 410 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 410”
Deutz-Fahr Agroplus V 410 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus V 410”
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 410”