11 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus 320from 2009No measured PTO figureTractor twoJohn Deere 5425 (A)2005–2008No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (2009–2009; 2005–2008). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Agroplus 320 | 5425 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 80 hp | 79.9 hp | — |
| Engine declared | Same 1000.3 WTI 2 E3 | John Deere-PowerTech 4.045 T 40 | differs |
| Displacement declared | 3.00 L | 4.52 L | +51% 5425 (A) |
| Maximum torque declared | 229 lb·ft · 310 N·m | 208 lb·ft · 282 N·m | +10% Agroplus 320 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Hydraulically operated single-plate dry clutch | Pedal operated dry double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 10.8 gpm · 41 L/min | 18.7 gpm · 70.8 L/min | +73% 5425 (A) |
| Pressure declared | — | 3,408 psi · 235 bar | — |
| Rear PTO speeds declared | 540/540E/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,518 lb · 3,410 kg | 6,799 lb · 3,084 kg | +11% Agroplus 320 |
| Wheelbase declared | 82.7 in · 2,100 mm | 85.7 in · 2,178 mm | — |
| Length declared | 140.2 in · 3,560 mm | 151.5 in · 3,848 mm | +8% 5425 (A) |
| Width declared | 81.5–91.7 in · 2,070–2,330 mm | 74.1 in · 1,882 mm | differs |
| Ground clearance declared | 15.4 in · 390 mm | 18.5 in · 470 mm | +21% 5425 (A) |
| Turning radius, braked declared | — | 10.2 ft · 3.10 m | — |
| Fuel tank declared | 95.1 qt · 90 L | 100.0 qt · 94.6 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus 320 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 320”
John Deere 5425 (A) sources
- Source: Traktorenlexikon, “John Deere 5425”