3 material differences · fewer than 12
Tractor oneDeutz-Fahr Agrokid 40 (45)2005–2007No measured PTO figureTractor twoHürlimann Prince 445 DT1995–1999No measured PTO figure
Which should you choose?
Read our verdict on the Agrokid 40 (45) and the Prince 445 DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
3 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | Agrokid 40 (45) | Prince 445 DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 39.4 hp | 41.4 hp | — |
| Engine declared | Mitsubishi S4L-T 61 ST (ab 2006: S4L-Y 1 T 62 ST) | MITSUBISHI K4 F-D Turbo | differs |
| Displacement declared | 1.50 L | 1.49 L | — |
| Transmission | |||
| Top speed declared | 19.6 mph · 31.5 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Mechanically operated dry SAME double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 1.8 gpm · 7.0 L/min | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,866 lb · 1,300 kg | 2,734 lb · 1,240 kg | — |
| Maximum permissible mass declared | 5,291 lb · 2,400 kg | — | — |
| Wheelbase declared | 68.7 in · 1,746 mm | 66.9 in · 1,700 mm | — |
| Length declared | 117.3 in · 2,980 mm | 119.3 in · 3,030 mm | — |
| Width declared | 48.0–53.5 in · 1,220–1,360 mm | 49.6–53.5 in · 1,260–1,360 mm | — |
| Ground clearance declared | 15.4 in · 392 mm | 15.4 in · 390 mm | — |
| Turning radius, braked declared | — | 10.8 ft · 3.30 m | — |
| Fuel tank declared | 40.2 qt · 38 L | 30.6 qt · 29.0 L | +31% Agrokid 40 (45) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agrokid 40 (45) sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrokid 40”
Hürlimann Prince 445 DT sources
- Source: Traktorenlexikon, “Hürlimann Prince 445”