10 material differences · fewer than 12
Tractor oneDeutz-Fahr Agrocompact 70 V/F 31998–2006No measured PTO figureTractor twoVALMET 7001997–2002No measured PTO figure
Which should you choose?
Read our verdict on the Agrocompact 70 V/F 3 and the 700 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Agrocompact 70 V/F 3 | 700 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | SLH 1.000.3 WT | VALMET 320 DS or DSRE | differs |
| Displacement declared | 3.00 L | 3.30 L | +10% 700 |
| Maximum torque declared | 192 lb·ft · 260 N·m | 214 lb·ft · 290 N·m | +12% 700 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | — | 14.7 gpm · 55.7 L/min | — |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Three-point lift, at the coupling points declared | 6,614 lb · 3,000 kg | 6,294 lb · 2,855 kg | — |
| Rear PTO speeds declared | 540/540E/1000 rpm | 540E/540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,456–5,567 lb · 2,475–2,525 kg | 7,077 lb · 3,210 kg | differs |
| Wheelbase declared | 75.8 in · 1,926 mm | 83.1 in · 2,112 mm | +10% 700 |
| Length declared | 140.8 in · 3,576 mm | 147.4 in · 3,745 mm | — |
| Width declared | 47.2–56.1 in · 1,199–1,425 mm | 84.2 in · 2,139 mm | differs |
| Ground clearance declared | 8.3–9.1 in · 210–230 mm | 19.9 in · 505 mm | differs |
| Turning radius, braked declared | — | 11.5 ft · 3.50 m | — |
| Fuel tank declared | 74.0 qt · 70 L | 83.5 qt · 79.0 L | +13% 700 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agrocompact 70 V/F 3 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrocompact 70 F”
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 67”
VALMET 700 sources
- Source: Traktorenlexikon, “Valmet 700/II”