7 material differences · fewer than 12
Tractor oneDeutz (KHD) F4L 514/51956–1966No measured PTO figureTractor twoInternational Harvester 824 (A)1971–1974No measured PTO figure
Which should you choose?
Read our verdict on the F4L 514/5 and the 824 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | F4L 514/5 | 824 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 63.8 hp | 73.0 hp | +14% 824 (A) |
| Engine declared | KHD F4L 514 | INTERNATIONAL-HARVESTER D-239 or D-246 | differs |
| Displacement declared | 5.32 L | — | — |
| Maximum torque declared | 210 lb·ft · 285 N·m | 185 lb·ft · 251 N·m | +14% F4L 514/5 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30.0 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | — | Pedal-operated dry LuK single-disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 7.7 gpm · 29.2 L/min | — |
| Pressure declared | — | 2,988 psi · 206 bar | — |
| Rear PTO speeds declared | 588 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,669 lb · 3,025 kg | 6,934 lb · 3,145 kg | — |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | — | — |
| Wheelbase declared | 96.1 in · 2,440 mm | 83.5 in · 2,120 mm | +15% F4L 514/5 |
| Length declared | 153.5 in · 3,900 mm | 131.4 in · 3,337 mm | +17% F4L 514/5 |
| Width declared | 77.2 in · 1,962 mm | 78.3 in · 1,990 mm | — |
| Ground clearance declared | 18.5 in · 470 mm | 17.8 in · 453 mm | — |
| Turning radius, braked declared | 13.1 ft · 4.00 m | 12.5 ft · 3.80 m | +5% F4L 514/5 |
| Fuel tank declared | 89.8 qt · 85 L | 74.0 qt · 70.0 L | +21% F4L 514/5 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) F4L 514/5 sources
- Source: Traktorenlexikon, “Deutz F4L 514/5”
- Source: Traktorenlexikon, “Fahr D 55 L”
International Harvester 824 (A) sources
- Source: Traktorenlexikon, “McCormick 824 (A)”