6 material differences · fewer than 12
Tractor oneDeutz (KHD) F2L 514/541954–1955No measured PTO figureTractor twoFahr D 30 UL1951No measured PTO figure
Which should you choose?
Read our verdict on the F2L 514/54 and the D 30 UL → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | F2L 514/54 | D 30 UL | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 30 hp | 29.6 hp | — |
| Engine declared | KHD F2L 514 | KHD F2L 514 | — |
| Displacement declared | 2.66 L | 2.66 L | — |
| Maximum torque declared | 105 lb·ft · 142 N·m | 105 lb·ft · 142 N·m | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 12.2 mph · 19.6 km/h | — |
| Clutch declared | — | Pedal operated dry Fichtel & Sachs single plate clutch | — |
| Hydraulics & hitch | |||
| Pressure declared | 1,707 psi · 118 bar | 3,129 psi · 216 bar | +83% D 30 UL |
| Rear PTO speeds declared | 585 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,244–4,354 lb · 1,925–1,975 kg | 4,696 lb · 2,130 kg | differs |
| Maximum permissible mass declared | 5,732 lb · 2,600 kg | — | — |
| Wheelbase declared | 78.9 in · 2,005 mm | 86.4 in · 2,195 mm | +9% D 30 UL |
| Length declared | 124.6 in · 3,165 mm | 117.7 in · 2,990 mm | +6% F2L 514/54 |
| Width declared | 61.0 in · 1,550 mm | 59.6 in · 1,515 mm | — |
| Ground clearance declared | 15.0 in · 380 mm | 11.8 in · 300 mm | +27% F2L 514/54 |
| Turning radius, braked declared | 10.5 ft · 3.20 m | — | — |
| Fuel tank declared | — | 31.7 qt · 30 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) F2L 514/54 sources
- Source: Traktorenlexikon, “Deutz F2L 514/54”
- Source: Traktorenlexikon, “Fahr D 270”
Fahr D 30 UL sources
- Source: Traktorenlexikon, “Fahr D 30 UL”
- Source: Traktorenlexikon, “Fahr D 270”