10 material differences · fewer than 12
Tractor oneDeutz (KHD) D 90061968–1970No measured PTO figureTractor twoVALMET 702 S (A)1974–1979No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1968–1970; 1974–1979). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | D 9006 | 702 S (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 90.3 hp | 89.7 hp | — |
| Engine declared | KHD F6L 912 | VALMET 411 BS | differs |
| Displacement declared | 5.65 L | 4.18 L | +35% D 9006 |
| Maximum torque declared | 236 lb·ft · 320 N·m | 235 lb·ft · 319 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Dry Walterscheid double clutch operated by two-stage pedal | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 9.2 gpm · 34.7 L/min | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,058 lb · 3,655 kg | 7,551 lb · 3,425 kg | +7% D 9006 |
| Wheelbase declared | 100.4 in · 2,550 mm | 88.2 in · 2,240 mm | +14% D 9006 |
| Length declared | 165.7 in · 4,210 mm | 150.4 in · 3,820 mm | +10% D 9006 |
| Width declared | 81.7 in · 2,075 mm | 73.6 in · 1,869 mm | +11% D 9006 |
| Ground clearance declared | 22.2 in · 565 mm | 17.7 in · 450 mm | +26% D 9006 |
| Turning radius, braked declared | 13.1 ft · 4.00 m | 12.4 ft · 3.79 m | +6% D 9006 |
| Fuel tank declared | 126.8 qt · 120 L | 71.9 qt · 68.0 L | +76% D 9006 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 9006 sources
- Source: Traktorenlexikon, “Deutz D 9006”
- Source: Traktorenlexikon, “Deutz-Fahr DX 110”
VALMET 702 S (A) sources
- Source: Traktorenlexikon, “Valmet 702 S”