10 material differences · fewer than 12
Tractor oneDeutz (KHD) D 60051966–1967No measured PTO figureTractor twoMassey Ferguson MF 651958–1961No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (34%); the drive differs (Two-wheel or four-wheel drive; 2WD); they were not built in overlapping years (1966–1967; 1958–1961). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D 6005 | MF 65 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 57.0 hp | 57 hp | — |
| Engine declared | KHD F4L 812 D | Perkins A 4-192 Y | differs |
| Displacement declared | 3.40 L | 3.35 L | — |
| Maximum torque declared | 148 lb·ft · 200 N·m | 136 lb·ft · 184 N·m | +9% D 6005 |
| Transmission | |||
| Top speed declared | 12.4–16.8 mph · 20–27 km/h | 12.4 mph · 20 km/h | differs |
| Clutch declared | Dry double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.0 gpm · 15.1 L/min | — |
| Pressure declared | 2,901 psi · 200 bar | 2,489 psi · 172 bar | +16% D 6005 |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,743 lb · 2,605 kg | 4,299 lb · 1,950 kg | +34% D 6005 |
| Maximum permissible mass declared | 11,023 lb · 5,000 kg | — | — |
| Wheelbase declared | 84.6 in · 2,150 mm | 84.2 in · 2,138 mm | — |
| Length declared | 144.5 in · 3,670 mm | 131.3 in · 3,335 mm | +10% D 6005 |
| Width declared | 76.8 in · 1,950 mm | 72.4 in · 1,840 mm | +6% D 6005 |
| Ground clearance declared | 19.9 in · 505 mm | 14.3 in · 362 mm | +40% D 6005 |
| Turning radius, braked declared | 10.8 ft · 3.30 m | 11.5 ft · 3.50 m | +6% MF 65 |
| Fuel tank declared | 84.5 qt · 80 L | 52.8 qt · 50 L | +60% D 6005 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 6005 sources
- Source: Traktorenlexikon, “Deutz D 6005”
Massey Ferguson MF 65 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 65”