Deutz (KHD) D 5505 or International Harvester Farmall 544?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the D 5505 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Farmall 544 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The International Harvester Farmall 544 suits loader and hydraulic implement work better on this data: 68% (18.4 L/min / 4.9 gpm) more hydraulic flow.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | D 5505 | Farmall 544 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 38.1 kW (51.1 hp)Traktorenlexikon, “Deutz D 5505” | 38.2 kW (51.2 hp)Traktorenlexikon, “Farmall Farmall 544” | Not comparableNot comparable on power at the PTO shaft: the D 5505 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Farmall 544 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the D 5505 and the Farmall 544. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the D 5505 and the Farmall 544. |
| Which pumps more oil for implements? | 27 L/min (7.1 gpm)Traktorenlexikon, “Deutz D 5505” | 45.4 L/min (12.0 gpm)Traktorenlexikon, “Farmall Farmall 544” | AheadThe International Harvester Farmall 544 has 68% more hydraulic flow (18.4 L/min / 4.9 gpm) than the Deutz D 5505 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | — | — | No figureNo call on three-point lift: no figure on record for the D 5505 and the Farmall 544. |
| Which is heavier, for traction? | 2,450 kg (5,401 lb)Traktorenlexikon, “Deutz D 5505” | 2,766 kg (6,098 lb)Traktorenlexikon, “Farmall Farmall 544” | Ahead (a fact, not an advantage)The International Harvester Farmall 544 is 13% heavier (316 kg / 697 lb) than the Deutz D 5505 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 3,900 kg (8,598 lb)Traktorenlexikon, “Deutz D 5505” | — | No figureNo call on maximum permissible mass: no figure on record for the Farmall 544. |
| Which has the wider choice of gears? | 8 forwardTraktorenlexikon, “Deutz D 5505” | Stepless (CVT)Traktorenlexikon, “Farmall Farmall 544” | DifferTransmissions differ in kind: the Deutz D 5505 has 8 forward gears and the International Harvester Farmall 544 is stepless (CVT) — not called. |
| Which offers a creeper range? | YesTraktorenlexikon, “Deutz D 5505” | — | No figureNo call on a creeper range: not stated for the Farmall 544. |
| Which is faster on the road? | 20 km/h (12.4 mph) to 28 km/h (17.4 mph)Traktorenlexikon, “Deutz D 5505” | 30 km/h (18.6 mph)Traktorenlexikon, “Farmall Farmall 544” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Deutz D 5505” | 540/1000 rpmTraktorenlexikon, “Farmall Farmall 544” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz D 5505” | dependent (stops with the clutch)Traktorenlexikon, “Farmall Farmall 544” | AheadThe Deutz D 5505 has an independent PTO; the International Harvester Farmall 544’s is dependent (stops with the clutch). |
| Which drives on both axles? | 2WDTraktorenlexikon, “Deutz D 5505” | 2WDTraktorenlexikon, “Farmall Farmall 544” | EvenEven on drive: all two-wheel drive. |
| Which is newer, and what about parts? | 1965–1967 | 1968–1973 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The International Harvester Farmall 544 has 68% more hydraulic flow (18.4 L/min / 4.9 gpm) than the Deutz D 5505 (both pump flow, as stated by the source).
- The International Harvester Farmall 544 is 13% heavier (316 kg / 697 lb) than the Deutz D 5505 (both unladen weight, as stated by the source).
- The Deutz D 5505 has an independent PTO; the International Harvester Farmall 544’s is dependent (stops with the clutch).
- Transmissions differ in kind: the Deutz D 5505 has 8 forward gears and the International Harvester Farmall 544 is stepless (CVT) — not called.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: all two-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the D 5505 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Farmall 544 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources