7 material differences · fewer than 12
Tractor oneDeutz (KHD) D 5006 V/VAfrom 1974No measured PTO figureTractor twoFendt Farmer 2 Wfrom 1971No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1974–1974; 1971–1971). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D 5006 V/VA | Farmer 2 W | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.1 hp | 44.1 hp | — |
| Engine declared | KHD F3L 912 | MWM D 325-3 | differs |
| Displacement declared | 2.83 L | 2.55 L | +11% D 5006 V/VA |
| Maximum torque declared | 114 lb·ft · 155 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25.0 km/h | 12.2–15.5 mph · 19.6–25.0 km/h | differs |
| Clutch declared | — | Tornado duplex clutch by Fichtel & Sachs | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 8.0 gpm · 30.5 L/min | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,395 lb · 1,540 kg | 3,307 lb · 1,500 kg | — |
| Wheelbase declared | 74.4 in · 1,890 mm | 69.9 in · 1,775 mm | +6% D 5006 V/VA |
| Length declared | 125.2 in · 3,180 mm | 108.3 in · 2,750 mm | +16% D 5006 V/VA |
| Width declared | 37.4 in · 950 mm | 37.4 in · 950 mm | — |
| Ground clearance declared | 11.8 in · 300 mm | 9.1 in · 230 mm | +30% D 5006 V/VA |
| Turning radius, braked declared | 8.7 ft · 2.65 m | 4.9 ft · 1.50 m | +77% D 5006 V/VA |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 5006 V/VA sources
- Source: Traktorenlexikon, “Deutz D 5006 V/VA”
- Source: Traktorenlexikon, “Deutz D 4006 P”
Fendt Farmer 2 W sources
- Source: Traktorenlexikon, “Fendt Farmer 2 W”
- Source: Traktorenlexikon, “Renault 60 R7253”