10 material differences · fewer than 12
Tractor oneDeutz (KHD) D 501960–1962No measured PTO figureTractor twoIMT 5881970–1980No measured PTO figure
Which should you choose?
Read our verdict on the D 50 and the 588 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | D 50 | 588 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 45.2 hp | 57.3 hp | +27% 588 |
| Engine declared | KHD F4L 712 | IMR-PERKINS M-34/T | differs |
| Displacement declared | 3.40 L | 3.34 L | — |
| Maximum torque declared | 127 lb·ft · 172 N·m | 154 lb·ft · 209 N·m | +22% 588 |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 13.7 mph · 22 km/h | +10% 588 |
| Clutch declared | Dry double clutch operated by two-stage pedal | Pedal-operated, dry two-stage KRON-NOVI double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.0 gpm · 15.1 L/min | — |
| Pressure declared | 2,134 psi · 147 bar | — | — |
| Rear PTO speeds declared | 590 | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,707 lb · 2,135 kg | 5,071 lb · 2,300 kg | +8% 588 |
| Maximum permissible mass declared | 7,055 lb · 3,200 kg | — | — |
| Wheelbase declared | 87.8 in · 2,230 mm | 83.4 in · 2,118 mm | +5% D 50 |
| Length declared | 142.9 in · 3,630 mm | 146.3 in · 3,715 mm | — |
| Width declared | 73.4 in · 1,865 mm | 71.2 in · 1,808 mm | — |
| Ground clearance declared | 20.3 in · 515 mm | 16.9 in · 430 mm | +20% D 50 |
| Turning radius, braked declared | 11.3 ft · 3.45 m | 12.5 ft · 3.80 m | +10% 588 |
| Fuel tank declared | 57.1 qt · 54 L | 52.8 qt · 50.0 L | +8% D 50 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 50 sources
Source
- Source: Traktorenlexikon, “Deutz D 50”
IMT 588 sources
Source
- Source: Traktorenlexikon, “IMT 558”