9 material differences · fewer than 12
Tractor oneDeutz (KHD) D 30051965–1967No measured PTO figureTractor twoSAME Delfino 32 (DT)1970–1971No measured PTO figure
Which should you choose?
Read our verdict on the D 3005 and the Delfino 32 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | D 3005 | Delfino 32 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 27.5 hp | 29.6 hp | +8% Delfino 32 (DT) |
| Engine declared | — | SAME DA 027-952 L | — |
| Displacement declared | — | 1.70 L | — |
| Maximum torque declared | 67 lb·ft · 91 N·m | 76 lb·ft · 103 N·m | +13% Delfino 32 (DT) |
| Transmission | |||
| Top speed declared | 12.4–16.1 mph · 20.0–25.9 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | — | Pedal operated dry two stage SAME double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 3.0 gpm · 11.2 L/min | — |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,605 lb · 1,635 kg | 2,601 lb · 1,180 kg | +39% D 3005 |
| Maximum permissible mass declared | 6,614 lb · 3,000 kg | — | — |
| Wheelbase declared | 73.4 in · 1,865 mm | 67.7 in · 1,720 mm | +8% D 3005 |
| Length declared | 127.8 in · 3,245 mm | 103.5 in · 2,630 mm | +23% D 3005 |
| Width declared | 60.4 in · 1,535 mm | 58.3–79.5 in · 1,480–2,020 mm | differs |
| Ground clearance declared | 15.9 in · 405 mm | 11.8 in · 300 mm | +35% D 3005 |
| Turning radius, braked declared | 10.7 ft · 3.25 m | 8.7 ft · 2.65 m | +23% D 3005 |
| Fuel tank declared | 67.6 qt · 64 L | 31.7 qt · 30.0 L | +113% D 3005 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 3005 sources
- Source: Traktorenlexikon, “Deutz D 3005”
SAME Delfino 32 (DT) sources
- Source: Traktorenlexikon, “SAME Delfino 32”