8 material differences · fewer than 12
Tractor oneDeutz (KHD) D 30051965–1967No measured PTO figureTractor twoFord 741/771 Workmaster1958–1962No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1965–1967; 1958–1962). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | D 3005 | 741/771 Workmaster | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 27.5 hp | 42.1 hp | +53% 741/771 Workmaster |
| Maximum torque declared | 67 lb·ft · 91 N·m | 121 lb·ft · 164 N·m | +80% 741/771 Workmaster |
| Transmission | |||
| Top speed declared | 12.4–16.1 mph · 20.0–25.9 km/h | 17.4 mph · 28 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.0 gpm · 15.0 L/min | — |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,605 lb · 1,635 kg | 3,400 lb · 1,542 kg | +6% D 3005 |
| Maximum permissible mass declared | 6,614 lb · 3,000 kg | — | — |
| Wheelbase declared | 73.4 in · 1,865 mm | 85.3 in · 2,167 mm | +16% 741/771 Workmaster |
| Length declared | 127.8 in · 3,245 mm | 132.0 in · 3,353 mm | — |
| Width declared | 60.4 in · 1,535 mm | 71.7 in · 1,821 mm | +19% 741/771 Workmaster |
| Ground clearance declared | 15.9 in · 405 mm | 27.5 in · 698 mm | +72% 741/771 Workmaster |
| Turning radius, braked declared | 10.7 ft · 3.25 m | 9.2 ft · 2.81 m | +16% D 3005 |
| Fuel tank declared | 67.6 qt · 64 L | 62.3 qt · 59.0 L | +8% D 3005 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 3005 sources
- Source: Traktorenlexikon, “Deutz D 3005”
Ford 741/771 Workmaster sources
- Source: Traktorenlexikon, “Ford 701”