3 material differences · fewer than 12
Tractor oneDeutz (KHD) D 251959No measured PTO figureTractor twoDeutz (KHD) D 25.11960No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1959–1959; 1960–1960). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
3 material differences · 12 fields identical or within 5%, which is not counted as material
| Field | D 25 | D 25.1 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 19.6 hp | 19.6 hp | — |
| Engine declared | KHD F2L 712 | KHD F2L 712 | — |
| Displacement declared | 1.70 L | 1.70 L | — |
| Maximum torque declared | 64 lb·ft · 86 N·m | 64 lb·ft · 86 N·m | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 12.4 mph · 20 km/h | — |
| Clutch declared | Pedal-operated dry single-disc clutch from Fichtel & Sachs | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 4.2 gpm · 16.0 L/min | — | — |
| Pressure declared | 1,707 psi · 118 bar | 2,134 psi · 147 bar | +25% D 25.1 |
| Rear PTO speeds declared | 257/540 rpm | 257/540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 2,921 lb · 1,325 kg | 2,921 lb · 1,325 kg | — |
| Maximum permissible mass declared | 4,850 lb · 2,200 kg | 5,071 lb · 2,300 kg | — |
| Wheelbase declared | 70.1 in · 1,780 mm | 74.8 in · 1,900 mm | +7% D 25.1 |
| Length declared | 115.7 in · 2,940 mm | 115.7 in · 2,940 mm | — |
| Width declared | 62.6 in · 1,590 mm | 62.6 in · 1,590 mm | — |
| Ground clearance declared | 14.2 in · 360 mm | 16.9 in · 430 mm | +19% D 25.1 |
| Turning radius, braked declared | 8.7 ft · 2.65 m | 8.5 ft · 2.60 m | — |
| Fuel tank declared | 31.7 qt · 30 L | 31.7 qt · 30 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 25 sources
- Source: Traktorenlexikon, “Deutz D 25”
- Source: Traktorenlexikon, “Deutz D 25.1”
- Source: Traktorenlexikon, “Deutz D 25 S”
Deutz (KHD) D 25.1 sources
- Source: Traktorenlexikon, “Deutz D 25.1”
- Source: Traktorenlexikon, “Deutz D 25.1 S”