3 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS DX 4.701984–1986No measured PTO figureTractor twoDeutz-Fahr DX 921982–1983No measured PTO figure
Which should you choose?
Read our verdict on the DX 4.70 and the DX 92 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
3 material differences · 12 fields identical or within 5%, which is not counted as material
| Field | DX 4.70 | DX 92 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 88.4 hp | 89 hp | — |
| Engine declared | KHD BF4L 913 | KHD BF4L 913 | — |
| Displacement declared | 4.09 L | 4.09 L | — |
| Maximum torque declared | 236 lb·ft · 320 N·m | 235 lb·ft · 318 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Independent dry double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 12.9 gpm · 48.8 L/min | 12.8 gpm · 48.6 L/min | — |
| Pressure declared | 3,481 psi · 240 bar | 3,481 psi · 240 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,488 lb · 3,850 kg | 8,477 lb · 3,845 kg | — |
| Maximum permissible mass declared | 12,787 lb · 5,800 kg | 13,669 lb · 6,200 kg | +7% DX 92 |
| Wheelbase declared | 91.7 in · 2,330 mm | 91.7 in · 2,330 mm | — |
| Length declared | 164.2 in · 4,170 mm | 159.1 in · 4,040 mm | — |
| Width declared | 90.7 in · 2,304 mm | 90.7 in · 2,304 mm | — |
| Ground clearance declared | 20.9 in · 530 mm | 23.2 in · 590 mm | +11% DX 92 |
| Fuel tank declared | 132.1 qt · 125.0 L | 126.8 qt · 120 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS DX 4.70 sources
- Source: Traktorenlexikon, “Deutz-Allis DX 4.70”
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 4.78”
Deutz-Fahr DX 92 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 92”
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 4.78”