DEUTZ-ALLIS 9150 vs John Deere 6920
12 material differences
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1989–1990; 2002–2007). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
12 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 9150 | 6920 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 149.9 hp | 148.0 hp | — |
| Engine declared | K.H.D. BF6L 913 C-TI | John Deere PowrTech 6.068 HLA-072/V2 or 6.068 HLA-73/4V HP | differs |
| Displacement declared | 6.13 L | 6.79 L | +11% 6920 |
| Maximum torque declared | — | 474 lb·ft · 642.0 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Pedal operated dry single-plate clutch type 14 | Pedal-operated, hydraulic wet Perma clutch II as multi-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | Closed centre | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 24.0 gpm · 90.7 L/min | — | — |
| Pressure declared | — | 3,017–3,220 psi · 208–222 bar | — |
| Three-point lift at ends declared | 7,211 lb · 3,271 kg | 18,894 lb · 8,570 kg | +162% 6920 |
| Rear PTO speeds declared | 540/1000 rpm | 540E/540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 13,521 lb · 6,133 kg | 14,528–14,639 lb · 6,590–6,640 kg | differs |
| Maximum permissible mass declared | — | 23,612 lb · 10,710 kg | — |
| Wheelbase declared | 120.0 in · 3,048 mm | 104.3 in · 2,650 mm | +15% 9150 |
| Length declared | 188.0 in · 4,775 mm | 211.8 in · 5,380 mm | +13% 6920 |
| Width declared | 96.0 in · 2,438 mm | 95.7 in · 2,430 mm | — |
| Height declared | 122.0 in · 3,099 mm | 114.8 in · 2,915 mm | +6% 9150 |
| Ground clearance declared | 23.0 in · 584 mm | 16.9 in · 430 mm | +36% 9150 |
| Turning radius, braked declared | 13.4 ft · 4.09 m | — | — |
| Fuel tank declared | 367.7 qt · 348.0 L | 264.2 qt · 250.0 L | +39% 9150 |
DEUTZ-ALLIS 9150 sources
Source
- Source: Traktorenlexikon, “Deutz-Allis 9150”
John Deere 6920 sources
Source
- Source: Traktorenlexikon, “John Deere 6920”
- Source: OECD test report 2033, 2003