7 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 80501985–1988No measured PTO figureTractor twoFendt Favorit 614 LSA1983–1993No measured PTO figure
Which should you choose?
Read our verdict on the 8050 and the Favorit 614 LSA → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 8050 | Favorit 614 LSA | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 151.9 hp | 152.2 hp | — |
| Engine declared | ALLIS-CHALMERS 670 TI | MWM TD 226.6.2 | differs |
| Displacement declared | 6.98 L | 6.24 L | +12% 8050 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 24.9 mph · 40 km/h | +33% Favorit 614 LSA |
| Clutch declared | electrohydraulically operated wet multi-plate clutch | Fichtel & Sachs, type GMFZ 360 | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 22.0 gpm · 83.3 L/min | — | — |
| Pressure declared | 3,771 psi · 260 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | — | — |
| Weight & dimensions | |||
| Unladen weight declared | 15,304 lb · 6,942 kg | 14,396–14,914 lb · 6,530–6,765 kg | differs |
| Wheelbase declared | 106.0 in · 2,692 mm | 105.9 in · 2,690 mm | — |
| Length declared | 187.0 in · 4,750 mm | 178.7–185.8 in · 4,540–4,719 mm | — |
| Width declared | 95.5 in · 2,426 mm | 93.7 in · 2,380 mm | — |
| Ground clearance declared | 22.0 in · 559 mm | 18.5 in · 470 mm | +19% 8050 |
| Turning radius, braked declared | 12.1 ft · 3.68 m | 19.4 ft · 5.90 m | +60% Favorit 614 LSA |
| Fuel tank declared | 239.9 qt · 227.0 L | 234.6 qt · 222 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 8050 sources
- Source: Traktorenlexikon, “Deutz-Allis 8050”
Fendt Favorit 614 LSA sources
- Source: Traktorenlexikon, “Fendt Favorit 614 LSA”
- Source: Traktorenlexikon, “Fendt Favorit 612 LSA”