11 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 62601986–1990No measured PTO figureTractor twoMassey Ferguson MF 360 (A)1987–1994No measured PTO figure
Which should you choose?
Read our verdict on the 6260 and the MF 360 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 6260 | MF 360 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 57.3 hp | 57.3 hp | — |
| Engine declared | KHD F3L 913 | Perkins AT 3.152-4 | differs |
| Displacement declared | 3.06 L | 2.50 L | +22% 6260 |
| Maximum torque declared | 144 lb·ft · 195 N·m | 134 lb·ft · 182 N·m | +7% 6260 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.5 gpm · 47.5 L/min | 5.0 gpm · 18.9 L/min | +151% 6260 |
| Three-point lift, at the coupling points declared | 5,291 lb · 2,400 kg | 4,255 lb · 1,930 kg | +24% 6260 |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,460 lb · 2,930 kg | 5,124 lb · 2,324 kg | +26% 6260 |
| Maximum permissible mass declared | 11,023 lb · 5,000 kg | — | — |
| Wheelbase declared | 79.2 in · 2,012 mm | 76.1 in · 1,933 mm | — |
| Length declared | 143.3 in · 3,640 mm | 129.1 in · 3,280 mm | +11% 6260 |
| Width declared | 84.2 in · 2,139 mm | 69.3 in · 1,760 mm | +22% 6260 |
| Ground clearance declared | 18.0 in · 457 mm | 8.9 in · 227 mm | +101% 6260 |
| Turning radius, braked declared | 11.8 ft · 3.60 m | — | — |
| Fuel tank declared | 79.3 qt · 75.0 L | 71.9 qt · 68 L | +10% 6260 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 6260 sources
- Source: Traktorenlexikon, “Deutz-Allis 6260”
- Source: Traktorenlexikon, “Fendt Farmer 260 S/SA”
Massey Ferguson MF 360 (A) sources
- Source: Traktorenlexikon, “Massey Ferguson MF 360”
- Source: Traktorenlexikon, “Massey Ferguson MF 253”