DEUTZ-ALLIS 6250 or John Deere 1130 (A)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 6250 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 1130 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The DEUTZ-ALLIS 6250 suits loader and hydraulic implement work better on this data: 83% (19.9 L/min / 5.3 gpm) more hydraulic flow and 29% (540 kg / 1,190 lb) more three-point lift.
- The DEUTZ-ALLIS 6250 suits road haulage better on this data: 43% (1,500 kg / 3,307 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 6250 | 1130 (A) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 37.5 kW (50.3 hp)Traktorenlexikon, “Deutz-Allis 6250” | 37.5 kW (50.3 hp)Traktorenlexikon, “John Deere 1130” | Not comparableNot comparable on power at the PTO shaft: the 6250 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 1130 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 6250 and the 1130 (A). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 6250 and the 1130 (A). |
| Which pumps more oil for implements? | 43.9 L/min (11.6 gpm)Traktorenlexikon, “Deutz-Allis 6250” | 24.0 L/min (6.3 gpm)Traktorenlexikon, “John Deere 1130” | AheadThe DEUTZ-ALLIS 6250 has 83% more hydraulic flow (19.9 L/min / 5.3 gpm) than the John Deere 1130 (A) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 2,400 kg (5,291 lb)Traktorenlexikon, “Deutz-Allis 6250” | 1,860 kg (4,101 lb)Traktorenlexikon, “John Deere 1130” | AheadThe DEUTZ-ALLIS 6250 has 29% more lift (540 kg / 1,190 lb) than the John Deere 1130 (A) (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 2,730 kg (6,019 lb)Traktorenlexikon, “Deutz-Allis 6250” | 2,291 kg (5,051 lb)Traktorenlexikon, “John Deere 1130” | Ahead (a fact, not an advantage)The DEUTZ-ALLIS 6250 is 19% heavier (439 kg / 968 lb) than the John Deere 1130 (A) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 5,000 kg (11,023 lb)Traktorenlexikon, “Deutz-Allis 6250” | 3,500 kg (7,716 lb)Traktorenlexikon, “John Deere 1130” | AheadThe DEUTZ-ALLIS 6250 has 43% higher maximum permissible mass (1,500 kg / 3,307 lb) than the John Deere 1130 (A) (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 8 to 16Traktorenlexikon, “Deutz-Allis 6250” | 8 to 16Traktorenlexikon, “John Deere 1130” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 6250 and the 1130 (A). |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Deutz-Allis 6250” | 25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “John Deere 1130” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Deutz-Allis 6250” | 540 rpm / 1000 rpmTraktorenlexikon, “John Deere 1130” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Allis 6250” | independentTraktorenlexikon, “John Deere 1130” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Deutz-Allis 6250” | Two-wheel or four-wheel driveTraktorenlexikon, “John Deere 1130” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1986–1990 | 1974–1977 | Ahead (a fact, not an advantage)The DEUTZ-ALLIS 6250 is newer: production began 12 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The DEUTZ-ALLIS 6250 has 83% more hydraulic flow (19.9 L/min / 5.3 gpm) than the John Deere 1130 (A) (both pump flow, as stated by the source).
- The DEUTZ-ALLIS 6250 has 29% more lift (540 kg / 1,190 lb) than the John Deere 1130 (A) (both lift at the hitch ends, as stated by the source).
- The DEUTZ-ALLIS 6250 is 19% heavier (439 kg / 968 lb) than the John Deere 1130 (A) (both unladen weight, as stated by the source).
- The DEUTZ-ALLIS 6250 has 43% higher maximum permissible mass (1,500 kg / 3,307 lb) than the John Deere 1130 (A) (both maximum permissible mass, as stated by the source).
- The DEUTZ-ALLIS 6250 is newer: production began 12 years later. We hold no parts-availability data, so there is no call on parts.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the 6250 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 1130 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power and a creeper range.
← Every figure for both machines, side by side, with sources