10 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 62501986–1990No measured PTO figureTractor twoFord 3930 (A)1990–1999No measured PTO figure
Which should you choose?
Read our verdict on the 6250 and the 3930 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 6250 | 3930 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 50.3 hp | 50.3 hp | — |
| Engine declared | KHD F3L 912 | Ford C 201 CID-NA | differs |
| Displacement declared | 2.83 L | 3.29 L | +16% 3930 (A) |
| Maximum torque declared | 122 lb·ft · 166 N·m | 137 lb·ft · 186 N·m | +12% 3930 (A) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Independent dry double clutch | Pedal-operated dry AP single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 11.6 gpm · 43.9 L/min | 8.8 gpm · 33.2 L/min | +32% 6250 |
| Pressure declared | — | 1,378–1,450 psi · 95–100 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,019 lb · 2,730 kg | 6,045 lb · 2,742 kg | — |
| Maximum permissible mass declared | 11,023 lb · 5,000 kg | — | — |
| Wheelbase declared | 79.2 in · 2,012 mm | 84.5 in · 2,146 mm | +7% 3930 (A) |
| Length declared | 137.4 in · 3,490 mm | 138.8 in · 3,525 mm | — |
| Width declared | 82.3 in · 2,090 mm | 69.7 in · 1,771 mm | +18% 6250 |
| Ground clearance declared | 16.1 in · 410 mm | 12.2 in · 310 mm | +32% 6250 |
| Fuel tank declared | 79.3 qt · 75.0 L | 69.4 qt · 65.7 L | +14% 6250 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 6250 sources
- Source: Traktorenlexikon, “Deutz-Allis 6250”
- Source: Traktorenlexikon, “Deutz D 4006 P”
Ford 3930 (A) sources
- Source: Traktorenlexikon, “Ford 3930”