7 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 62501986–1990No measured PTO figureTractor twoDeutz (KHD) Intrac 20021972–1974No measured PTO figure
Which should you choose?
Read our verdict on the 6250 and the Intrac 2002 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 6250 | Intrac 2002 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 50.3 hp | 50.0 hp | — |
| Engine declared | KHD F3L 912 | KHD F3L 912 H | differs |
| Displacement declared | 2.83 L | 2.83 L | — |
| Maximum torque declared | 122 lb·ft · 166 N·m | 135 lb·ft · 182 N·m | +10% Intrac 2002 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 6250 |
| Clutch declared | Independent dry double clutch | Independent dry double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 11.6 gpm · 43.9 L/min | — | — |
| Pressure declared | — | 2,538 psi · 175 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,019 lb · 2,730 kg | 5,908 lb · 2,680 kg | — |
| Maximum permissible mass declared | 11,023 lb · 5,000 kg | — | — |
| Wheelbase declared | 79.2 in · 2,012 mm | 84.6 in · 2,150 mm | +7% Intrac 2002 |
| Length declared | 137.4 in · 3,490 mm | 137.8 in · 3,500 mm | — |
| Width declared | 82.3 in · 2,090 mm | 74.4 in · 1,890 mm | +11% 6250 |
| Ground clearance declared | 16.1 in · 410 mm | 17.9 in · 455 mm | +11% Intrac 2002 |
| Turning radius, braked declared | — | 12.1 ft · 3.70 m | — |
| Fuel tank declared | 79.3 qt · 75.0 L | 91.9 qt · 87 L | +16% Intrac 2002 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 6250 sources
- Source: Traktorenlexikon, “Deutz-Allis 6250”
- Source: Traktorenlexikon, “Deutz D 4006 P”
Deutz (KHD) Intrac 2002 sources
- Source: Traktorenlexikon, “Deutz INTRAC 2002”