DEUTZ-ALLIS 6070 vs Deutz-Fahr DX 3.65

9 material differences · fewer than 12

Tractor one

1985–1988

No measured PTO figure

Tractor two

1987–1996

No measured PTO figure

Which should you choose?

Read our verdict on the 6070 and the DX 3.65 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

9 material differences · 4 fields identical or within 5%, which is not counted as material

DEUTZ-ALLIS 6070 and Deutz-Fahr DX 3.65, field by field
Field	6070	DX 3.65	Gap
Engine
Engine power, claimed claimed	70.0 hp	69.1 hp	—
Engine declared	ALLIS-CHALMERS 433 T	KHD F4L 912	differs
Displacement declared	3.29 L	3.77 L	+15% DX 3.65
Maximum torque declared	—	180 lb·ft · 244 N·m	—
Transmission
Top speed declared	15.5 mph · 25 km/h	24.9 mph · 40 km/h	+60% DX 3.65
Clutch declared	—	independent dry double clutch	—
Hydraulics & hitch
Hydraulic control declared	—	Constant flow	—
Pump flow declared	—	11.3 gpm · 42.6 L/min	—
Pressure declared	—	3,481 psi · 240 bar	—
Three-point lift at ends declared	—	7,275 lb · 3,300 kg	—
Rear PTO speeds declared	540 rpm	540/1000 rpm	differs
Weight & dimensions
Unladen weight declared	6,100 lb · 2,767 kg	7,496 lb · 3,400 kg	+23% DX 3.65
Maximum permissible mass declared	—	11,023 lb · 5,000 kg	—
Wheelbase declared	93.0 in · 2,362 mm	88.6 in · 2,250 mm	—
Length declared	146.5 in · 3,721 mm	150.4 in · 3,820 mm	—
Width declared	68.5 in · 1,740 mm	85.9 in · 2,183 mm	+25% DX 3.65
Height declared	103.2 in · 2,621 mm	101.6 in · 2,580 mm	—
Ground clearance declared	20.4 in · 518 mm	16.1 in · 408 mm	+27% 6070
Turning radius, braked declared	10.4 ft · 3.17 m	15.1 ft · 4.60 m	+45% DX 3.65
Fuel tank declared	127.9 qt · 121.0 L	76.1 qt · 72 L	+68% 6070

Source

Source