3 material differences · fewer than 12
Tractor oneDeuliewag D 351949–1952No measured PTO figureTractor twoInternational Harvester B-4141961–1966No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (34%); they were not built in overlapping years (1949–1952; 1961–1966). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
3 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | D 35 | B-414 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 35.51 hp | 35.5 hp | — |
| Engine declared | — | INTERNATIONAL HARVESTER BD-154 | — |
| Displacement declared | — | 2.52 L | — |
| Maximum torque declared | — | 114 lb·ft · 155 N·m | — |
| Transmission | |||
| Top speed declared | 13.7 mph · 22 km/h | 15.5 mph · 25 km/h | +14% B-414 |
| Clutch declared | — | Pedal operated, two-stage and dry BORG & BECK double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 7.5 gpm · 28.5 L/min | — |
| Rear PTO speeds declared | 540 rpm | — | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,960 lb · 2,250 kg | 3,693 lb · 1,675 kg | +34% D 35 |
| Wheelbase declared | — | 76.5 in · 1,943 mm | — |
| Length declared | 126.8 in · 3,220 mm | 125.2 in · 3,180 mm | — |
| Width declared | 65.0 in · 1,650 mm | 66.1 in · 1,680 mm | — |
| Ground clearance declared | 13.8 in · 350 mm | 18.5 in · 470 mm | +34% B-414 |
| Turning radius, braked declared | — | 10.2 ft · 3.10 m | — |
| Fuel tank declared | — | 50.9 qt · 48.2 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deuliewag D 35 sources
- Source: Traktorenlexikon, “Deuliewag D 33”
International Harvester B-414 sources
- Source: Traktorenlexikon, “McCormick B-414”
- Source: Traktorenlexikon, “IHC B-414”