4 material differences · fewer than 12
Tractor oneDeuliewag D 351949–1952No measured PTO figureTractor twoGüldner G 40 (Toledo)1962No measured PTO figure
Which should you choose?
Read our verdict on the D 35 and the G 40 (Toledo) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
4 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | D 35 | G 40 (Toledo) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 35.51 hp | 35.34 hp | — |
| Engine declared | — | Güldner 3 L 79 | — |
| Displacement declared | — | 2.36 L | — |
| Maximum torque declared | — | 95 lb·ft · 128 N·m | — |
| Transmission | |||
| Top speed declared | 13.7 mph · 22 km/h | 12.4–18.6 mph · 20–30 km/h | differs |
| Clutch declared | — | Foot-operated dry double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.2 gpm · 16.0 L/min | — |
| Pressure declared | — | 2,489 psi · 172 bar | — |
| Rear PTO speeds declared | 540 rpm | 540/1150 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,960 lb · 2,250 kg | 4,442 lb · 2,015 kg | +12% D 35 |
| Maximum permissible mass declared | — | 4,526 lb · 2,053 kg | — |
| Wheelbase declared | — | 76.9 in · 1,954 mm | — |
| Length declared | 126.8 in · 3,220 mm | 120.9 in · 3,070 mm | — |
| Width declared | 65.0 in · 1,650 mm | 61.9 in · 1,572 mm | — |
| Ground clearance declared | 13.8 in · 350 mm | 15.7 in · 400 mm | +14% G 40 (Toledo) |
| Turning radius, braked declared | — | 9.8 ft · 3.00 m | — |
| Fuel tank declared | — | 50.7 qt · 48 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deuliewag D 35 sources
- Source: Traktorenlexikon, “Deuliewag D 33”
Güldner G 40 (Toledo) sources
- Source: Traktorenlexikon, “Güldner G 40 Toledo”