4 material differences · fewer than 12
Tractor oneCounty 11241967–1971No measured PTO figureTractor twoDeutz-Fahr DX 1201980–1983No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1967–1971; 1980–1983). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
4 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 1124 | DX 120 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 110 hp | 108.0 hp | — |
| Engine declared | — | KHD F6L 913 | — |
| Displacement declared | — | 6.13 L | — |
| Maximum torque declared | — | 286 lb·ft · 388 N·m | — |
| Transmission | |||
| Top speed declared | 21.1 mph · 34 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | — | Independent dry double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 14.7 gpm · 55.7 L/min | — |
| Pressure declared | — | 3,046–3,771 psi · 210–260 bar | — |
| Rear PTO speeds declared | 1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 9,392 lb · 4,260 kg | 9,789 lb · 4,440 kg | — |
| Wheelbase declared | — | 105.8 in · 2,688 mm | — |
| Length declared | 161.0 in · 4,090 mm | 176.8 in · 4,490 mm | +10% DX 120 |
| Width declared | 86.0 in · 2,184 mm | 90.7 in · 2,304 mm | +5% DX 120 |
| Ground clearance declared | — | 23.2 in · 590 mm | — |
| Turning radius, braked declared | 16.4 ft · 5.00 m | — | — |
| Fuel tank declared | — | 126.8 qt · 120 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
County 1124 sources
- Source: Traktorenlexikon, “County 1124”
Deutz-Fahr DX 120 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 120”