8 material differences · fewer than 12
Tractor oneClaas Celtis 4462003–2008No measured PTO figureTractor twoDeutz-Fahr AgroStar 4.681993–1995No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2003–2008; 1993–1995). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Celtis 446 | AgroStar 4.68 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 91 hp | 90 hp | — |
| Engine declared | — | KHD BF4L 913 | — |
| Displacement declared | — | 4.09 L | — |
| Maximum torque declared | 269 lb·ft · 365 N·m | 259 lb·ft · 351 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 18.2 gpm · 69 L/min | 13.0 gpm · 49.2 L/min | +40% Celtis 446 |
| Pressure declared | 2,611 psi · 180 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000/750 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,356 lb · 3,790 kg | 9,259 lb · 4,200 kg | +11% AgroStar 4.68 |
| Maximum permissible mass declared | — | 16,535 lb · 7,500 kg | — |
| Wheelbase declared | 98.0 in · 2,489 mm | 96.5 in · 2,450 mm | — |
| Length declared | 155.8 in · 3,957 mm | 168.2 in · 4,272 mm | +8% AgroStar 4.68 |
| Width declared | 98.8 in · 2,510 mm | 90.2 in · 2,290 mm | +10% Celtis 446 |
| Ground clearance declared | 16.5 in · 420 mm | 18.3 in · 465 mm | +11% AgroStar 4.68 |
| Fuel tank declared | 153.2 qt · 145 L | 139.5 qt · 132 L | +10% Celtis 446 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Claas Celtis 446 sources
- Source: Traktorenlexikon, “Claas Celtis 446”
- Source: OECD test report 2226, 2005
Deutz-Fahr AgroStar 4.68 sources
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 4.68”
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 4.78”