10 material differences · fewer than 12
Tractor oneClaas Celtis 4362003–2008No measured PTO figureTractor twoNew Holland TD 85 D (A)2002–2004No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Celtis 436 | TD 85 D (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 83 hp | 82.9 hp | — |
| Engine declared | — | IVECO 8045.05-406 | — |
| Displacement declared | — | 3.91 L | — |
| Maximum torque declared | 246 lb·ft · 333 N·m | 170 lb·ft · 230 N·m | +45% Celtis 436 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 18.2 gpm · 69 L/min | 11.9 gpm · 45.2 L/min | +53% Celtis 436 |
| Pressure declared | 2,611 psi · 180 bar | 3,553 psi · 245 bar | +36% TD 85 D (A) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,289 lb · 3,760 kg | 6,978 lb · 3,165 kg | +19% Celtis 436 |
| Wheelbase declared | 98.0 in · 2,489 mm | 90.7 in · 2,305 mm | +8% Celtis 436 |
| Length declared | 152.4 in · 3,872 mm | 153.0 in · 3,885 mm | — |
| Width declared | 98.8 in · 2,510 mm | 77.4 in · 1,967 mm | +28% Celtis 436 |
| Ground clearance declared | 16.5 in · 420 mm | 14.0 in · 356 mm | +18% Celtis 436 |
| Fuel tank declared | 153.2 qt · 145 L | 97.2 qt · 92.0 L | +58% Celtis 436 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Claas Celtis 436 sources
- Source: Traktorenlexikon, “Claas Celtis 436”
- Source: OECD test report 2220, 2005
New Holland TD 85 D (A) sources
- Source: Traktorenlexikon, “New Holland TD 85 D”