9 material differences · fewer than 12
Tractor oneClaas Celtis 4362003–2008No measured PTO figureTractor twoDeutz-Fahr Agrotron K 90 (Profiline)2005–2008No measured PTO figure
Which should you choose?
Read our verdict on the Celtis 436 and the Agrotron K 90 (Profiline) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Celtis 436 | Agrotron K 90 (Profiline) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 83 hp | 82.9 hp | — |
| Engine declared | — | Deutz BF4M 2012 C | — |
| Displacement declared | — | 4.04 L | — |
| Maximum torque declared | 246 lb·ft · 333 N·m | 274 lb·ft · 372 N·m | +12% Agrotron K 90 (Profiline) |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 18.2 gpm · 69 L/min | 14.5 gpm · 55.0 L/min | +25% Celtis 436 |
| Pressure declared | 2,611 psi · 180 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,289 lb · 3,760 kg | 9,789 lb · 4,440 kg | +18% Agrotron K 90 (Profiline) |
| Wheelbase declared | 98.0 in · 2,489 mm | 95.2 in · 2,419 mm | — |
| Length declared | 152.4 in · 3,872 mm | 163.0 in · 4,139 mm | +7% Agrotron K 90 (Profiline) |
| Width declared | 98.8 in · 2,510 mm | 88.8 in · 2,256 mm | +11% Celtis 436 |
| Ground clearance declared | 16.5 in · 420 mm | 19.1 in · 485 mm | +15% Agrotron K 90 (Profiline) |
| Fuel tank declared | 153.2 qt · 145 L | 190.2 qt · 180 L | +24% Agrotron K 90 (Profiline) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Claas Celtis 436 sources
- Source: Traktorenlexikon, “Claas Celtis 436”
- Source: OECD test report 2220, 2005
Deutz-Fahr Agrotron K 90 (Profiline) sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron K 90”
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron K 120”