5 material differences · fewer than 12
Tractor oneClaas Celtis 4262003–2008No measured PTO figureTractor twoMassey Ferguson MF 5410 A2011–2014No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2003–2008; 2011–2014). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Celtis 426 | MF 5410 A | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74 hp | 74 hp | — |
| Engine declared | — | Perkins 1104 D-44 T | — |
| Displacement declared | — | 4.40 L | — |
| Maximum torque declared | 209 lb·ft · 283 N·m | 229 lb·ft · 310 N·m | +10% MF 5410 A |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 18.2 gpm · 69 L/min | — | — |
| Pressure declared | 2,611 psi · 180 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,223 lb · 3,730 kg | 8,378 lb · 3,800 kg | — |
| Maximum permissible mass declared | — | 18,739 lb · 8,500 kg | — |
| Wheelbase declared | 98.0 in · 2,489 mm | 97.0 in · 2,464 mm | — |
| Length declared | 149.8 in · 3,805 mm | 166.2 in · 4,221 mm | +11% MF 5410 A |
| Width declared | 98.8 in · 2,510 mm | 60.4–80.1 in · 1,533–2,034 mm | differs |
| Ground clearance declared | 15.0 in · 380 mm | 15.4 in · 390 mm | — |
| Fuel tank declared | 153.2 qt · 145 L | 137.4 qt · 130.0 L | +12% Celtis 426 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Claas Celtis 426 sources
- Source: Traktorenlexikon, “Claas Celtis 426”
- Source: OECD test report 2219, 2005
Massey Ferguson MF 5410 A sources
- Source: Traktorenlexikon, “Massey Ferguson MF 5410”