8 material differences · fewer than 12
Tractor oneClaas Celtis 4262003–2008No measured PTO figureTractor twoJohn Deere 5403 (A)2007–2008No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (74%); the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Celtis 426 | 5403 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74 hp | 73.1 hp | — |
| Engine declared | — | John Deere 3.029 TPY | — |
| Displacement declared | — | 2.90 L | — |
| Maximum torque declared | 209 lb·ft · 283 N·m | — | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6 mph · 30 km/h | +33% Celtis 426 |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 18.2 gpm · 69 L/min | 10.8 gpm · 41.0 L/min | +68% Celtis 426 |
| Pressure declared | 2,611 psi · 180 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,223 lb · 3,730 kg | 4,725 lb · 2,143 kg | +74% Celtis 426 |
| Wheelbase declared | 98.0 in · 2,489 mm | 80.3 in · 2,040 mm | +22% Celtis 426 |
| Length declared | 149.8 in · 3,805 mm | 138.4 in · 3,515 mm | +8% Celtis 426 |
| Width declared | 98.8 in · 2,510 mm | 73.4–89.6 in · 1,865–2,275 mm | differs |
| Ground clearance declared | 15.0 in · 380 mm | 15.0 in · 380 mm | — |
| Fuel tank declared | 153.2 qt · 145 L | 76.0 qt · 71.9 L | +102% Celtis 426 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Claas Celtis 426 sources
- Source: Traktorenlexikon, “Claas Celtis 426”
- Source: OECD test report 2219, 2005
John Deere 5403 (A) sources
- Source: Traktorenlexikon, “John Deere 5403”