Claas Celtis 426 vs Deutz-Fahr Agroplus 75
3 material differences · fewer than 12
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; 2WD / 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
3 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | Celtis 426 | Agroplus 75 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74 hp | 74.0 hp | — |
| Maximum torque declared | 209 lb·ft · 283 N·m | 218 lb·ft · 295 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 18.2 gpm · 69 L/min | — | — |
| Pressure declared | 2,611 psi · 180 bar | — | — |
| Three-point lift at ends declared | — | 7,937 lb · 3,600 kg | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,223 lb · 3,730 kg | 7,562 lb · 3,430 kg | +9% Celtis 426 |
| Maximum permissible mass declared | — | 13,669 lb · 6,200 kg | — |
| Wheelbase declared | 98.0 in · 2,489 mm | 93.7 in · 2,380 mm | — |
| Length declared | 149.8 in · 3,805 mm | 145.7 in · 3,700 mm | — |
| Width declared | 98.8 in · 2,510 mm | 81.1 in · 2,060 mm | +22% Celtis 426 |
| Height declared | 102.5 in · 2,604 mm | 103.3 in · 2,624 mm | — |
| Ground clearance declared | 15.0 in · 380 mm | 15.4–19.8 in · 392–502 mm | differs |
| Fuel tank declared | 153.2 qt · 145 L | 147.9 qt · 140 L | — |
Claas Celtis 426 sources
Source
- Source: Traktorenlexikon, “Claas Celtis 426”
- Source: OECD test report 2219, 2005
Deutz-Fahr Agroplus 75 sources
Source
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 75”