8 material differences · fewer than 12
Tractor oneCase-Steyr M 9094 a1994–2003No measured PTO figureTractor twoSAME Panther 95 (DT)1979–1981No measured PTO figure
Which should you choose?
Read our verdict on the M 9094 a and the Panther 95 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | M 9094 a | Panther 95 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.8 hp | 92.7 hp | — |
| Engine declared | Steyr-MWM WD 401.85 | SAME DA 1055 P | differs |
| Displacement declared | 4.16 L | 5.19 L | +25% Panther 95 (DT) |
| Maximum torque declared | — | 251 lb·ft · 340 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Dry Fichtel & Sachs double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.7 gpm · 48.1 L/min | 9.2 gpm · 35.0 L/min | +37% M 9094 a |
| Rear PTO speeds declared | 430/540/1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,708 lb · 3,950 kg | 7,242 lb · 3,285 kg | +20% M 9094 a |
| Maximum permissible mass declared | 14,330 lb · 6,500 kg | — | — |
| Wheelbase declared | 97.7 in · 2,481 mm | 98.4 in · 2,500 mm | — |
| Length declared | 165.9 in · 4,215 mm | 161.4 in · 4,100 mm | — |
| Width declared | 85.4 in · 2,170 mm | 82.7–102.4 in · 2,100–2,600 mm | differs |
| Ground clearance declared | 17.3 in · 440 mm | 17.9 in · 455 mm | — |
| Turning radius, braked declared | 14.1 ft · 4.30 m | 12.4 ft · 3.77 m | +14% M 9094 a |
| Fuel tank declared | 105.7 qt · 100.0 L | 101.4 qt · 96.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-Steyr M 9094 a sources
- Source: Traktorenlexikon, “Steyr M 9094 a”
- Source: Traktorenlexikon, “Steyr 9094”
SAME Panther 95 (DT) sources
- Source: Traktorenlexikon, “SAME Panther 95”