11 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 895 (DT)1990–1993No measured PTO figureTractor twoDeutz-Fahr Agroplus S 902005–2007No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1990–1993; 2005–2007). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 895 (DT) | Agroplus S 90 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 82 hp | 82 hp | — |
| Engine declared | IHC D-268 | Lamborghini 1000.4 WT | differs |
| Displacement declared | 4.39 L | 4.00 L | +10% 895 (DT) |
| Maximum torque declared | 209 lb·ft · 284 N·m | 257 lb·ft · 348 N·m | +23% Agroplus S 90 |
| Transmission | |||
| Top speed declared | 21.7 mph · 35 km/h | 24.9 mph · 40 km/h | +14% Agroplus S 90 |
| Clutch declared | Pedal-operated dry Rockford single-plate clutch as driving clutch | Single-disc dry clutch | differs |
| Hydraulics & hitch | |||
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,863 lb · 3,113 kg | 5,952 lb · 2,700 kg | +15% 895 (DT) |
| Wheelbase declared | 88.0 in · 2,235 mm | 80.9 in · 2,056 mm | +9% 895 (DT) |
| Length declared | 142.0 in · 3,607 mm | 145.9 in · 3,706 mm | — |
| Width declared | 78.0 in · 1,981 mm | 59.1–76.0 in · 1,500–1,930 mm | differs |
| Ground clearance declared | 22.0 in · 559 mm | 10.2 in · 260 mm | +115% 895 (DT) |
| Fuel tank declared | 118.3 qt · 112.0 L | 58.1 qt · 55 L | +104% 895 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 895 (DT) sources
- Source: Traktorenlexikon, “Case-IH 895”
- Source: Traktorenlexikon, “Case-IH 4230”
Deutz-Fahr Agroplus S 90 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 90”