7 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 595 (DT)1990–1993No measured PTO figureTractor twoHürlimann H-358 "Prestige"1989–1998No measured PTO figure
Which should you choose?
Read our verdict on the 595 (DT) and the H-358 "Prestige" → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 595 (DT) | H-358 "Prestige" | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 59.1 hp | 59.1 hp | — |
| Engine declared | IHC D-206 | Hürlimann H-1000.3 W | differs |
| Displacement declared | 3.38 L | 3.00 L | +13% 595 (DT) |
| Maximum torque declared | 162 lb·ft · 220 N·m | 149 lb·ft · 202 N·m | +9% 595 (DT) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Pedal-operated dry Laycock single-disc clutch | Pedal-operated dry SLH single-plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | — | 7.5 gpm · 28.5 L/min | — |
| Pressure declared | — | 3,046 psi · 210 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,440 lb · 2,921 kg | 6,118 lb · 2,775 kg | — |
| Wheelbase declared | 84.5 in · 2,146 mm | 83.9 in · 2,130 mm | — |
| Length declared | 142.0 in · 3,607 mm | 148.0 in · 3,760 mm | — |
| Width declared | 75.0 in · 1,905 mm | 70.5–93.7 in · 1,790–2,380 mm | differs |
| Ground clearance declared | 22.1 in · 561 mm | 15.4 in · 390 mm | +44% 595 (DT) |
| Turning radius, braked declared | 11.7 ft · 3.56 m | — | — |
| Fuel tank declared | 80.0 qt · 75.7 L | 74.0 qt · 70.0 L | +8% 595 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 595 (DT) sources
- Source: Traktorenlexikon, “Case-IH 595”
- Source: Traktorenlexikon, “Case-IH 3230”
Hürlimann H-358 "Prestige" sources
- Source: Traktorenlexikon, “Hürlimann H 358”