9 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 495 (DT)1990–1993No measured PTO figureTractor twoInternational Harvester 4851981–1990No measured PTO figure
Which should you choose?
Read our verdict on the 495 (DT) and the 485 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 495 (DT) | 485 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 51.2 hp | 51.2 hp | — |
| Engine declared | IHC D-179 | INTERNATIONAL-HARVESTER D-179 | differs |
| Displacement declared | 2.93 L | 2.93 L | — |
| Maximum torque declared | 134 lb·ft · 182 N·m | 131 lb·ft · 177 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 495 (DT) |
| Clutch declared | Pedal-operated dry single-disc clutch and hand lever operated wet multi-disc clutch | Pedal-operated dry Laycock single-disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 15.6 gpm · 59.2 L/min | 12.4 gpm · 46.9 L/min | +26% 495 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,199 lb · 2,358 kg | 5,622 lb · 2,550 kg | +8% 485 |
| Wheelbase declared | 79.1 in · 2,010 mm | 84.6 in · 2,150 mm | +7% 485 |
| Length declared | 136.0 in · 3,454 mm | 141.3 in · 3,590 mm | — |
| Width declared | 66.0 in · 1,676 mm | 72.8 in · 1,850 mm | +10% 485 |
| Ground clearance declared | 22.1 in · 561 mm | 18.9 in · 480 mm | +17% 495 (DT) |
| Turning radius, braked declared | 11.1 ft · 3.38 m | 11.1 ft · 3.37 m | — |
| Fuel tank declared | 80.0 qt · 75.7 L | 118.3 qt · 112.0 L | +48% 485 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 495 (DT) sources
- Source: Traktorenlexikon, “Case-IH 495”
- Source: Traktorenlexikon, “IHC 553”
International Harvester 485 sources
- Source: Traktorenlexikon, “IHC 485 (XL)”
- Source: Traktorenlexikon, “McCormick 523”