10 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 4210 (DT)1993–1998No measured PTO figureTractor twoVALMET 465 (465-4)1993–1997No measured PTO figure
Which should you choose?
Read our verdict on the 4210 (DT) and the 465 (465-4) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 4210 (DT) | 465 (465-4) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | IHC D-239 | VALMET 320 DS | differs |
| Displacement declared | 3.91 L | 3.30 L | +19% 4210 (DT) |
| Maximum torque declared | 184 lb·ft · 250 N·m | 192 lb·ft · 260 N·m | — |
| Transmission | |||
| Top speed declared | 21.7 mph · 35 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | — | 14.5 gpm · 55.0 L/min | — |
| Pressure declared | 2,698 psi · 186 bar | 2,901 psi · 200 bar | +8% 465 (465-4) |
| Three-point lift, at the coupling points declared | 6,393 lb · 2,900 kg | 5,688 lb · 2,580 kg | +12% 4210 (DT) |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540E/540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,832 lb · 3,099 kg | 6,217 lb · 2,820 kg | +10% 4210 (DT) |
| Wheelbase declared | 88.7 in · 2,253 mm | 83.1 in · 2,112 mm | +7% 4210 (DT) |
| Length declared | 148.0 in · 3,759 mm | 146.1 in · 3,710 mm | — |
| Width declared | 73.0–92.7 in · 1,854–2,354 mm | 79.9 in · 2,030 mm | differs |
| Ground clearance declared | — | 15.9 in · 405 mm | — |
| Turning radius, braked declared | — | 11.5 ft · 3.50 m | — |
| Fuel tank declared | 118.3 qt · 112.0 L | 77.1 qt · 73.0 L | +53% 4210 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 4210 (DT) sources
- Source: Traktorenlexikon, “Case-IH 4210”
VALMET 465 (465-4) sources
- Source: Traktorenlexikon, “Valmet 465”