6 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 4210 (DT)1993–1998No measured PTO figureTractor twoLamborghini 674-70 (DT)1995–2000No measured PTO figure
Which should you choose?
Read our verdict on the 4210 (DT) and the 674-70 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 4210 (DT) | 674-70 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | IHC D-239 | SAME 1000.4 W 4 | differs |
| Displacement declared | 3.91 L | 4.00 L | — |
| Maximum torque declared | 184 lb·ft · 250 N·m | 182 lb·ft · 247 N·m | — |
| Transmission | |||
| Top speed declared | 21.7 mph · 35 km/h | 24.9 mph · 40 km/h | +14% 674-70 (DT) |
| Clutch declared | — | Pedal operated dry single plate clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pressure declared | 2,698 psi · 186 bar | 2,176 psi · 150 bar | +24% 4210 (DT) |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,832 lb · 3,099 kg | 5,975 lb · 2,710 kg | +14% 4210 (DT) |
| Maximum permissible mass declared | — | 11,023 lb · 5,000 kg | — |
| Wheelbase declared | 88.7 in · 2,253 mm | 88.0 in · 2,235 mm | — |
| Length declared | 148.0 in · 3,759 mm | 146.5 in · 3,720 mm | — |
| Width declared | 73.0–92.7 in · 1,854–2,354 mm | 75.6–91.3 in · 1,920–2,320 mm | — |
| Ground clearance declared | — | 19.9 in · 505 mm | — |
| Fuel tank declared | 118.3 qt · 112.0 L | 95.1 qt · 90.0 L | +24% 4210 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 4210 (DT) sources
- Source: Traktorenlexikon, “Case-IH 4210”
Lamborghini 674-70 (DT) sources
- Source: Traktorenlexikon, “Lamborghini Sprint 674-70 DT A”