10 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 4210 (DT)1993–1998No measured PTO figureTractor twoLamborghini 574-70 (DT)1993–2004No measured PTO figure
Which should you choose?
Read our verdict on the 4210 (DT) and the 574-70 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 4210 (DT) | 574-70 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | IHC D-239 | SAME 1000.3 AT | differs |
| Displacement declared | 3.91 L | 3.00 L | +30% 4210 (DT) |
| Maximum torque declared | 184 lb·ft · 250 N·m | 178 lb·ft · 241 N·m | — |
| Transmission | |||
| Top speed declared | 21.7 mph · 35 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Pedal-operated dry Lamborghini double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | — | 8.2 gpm · 31.0 L/min | — |
| Pressure declared | 2,698 psi · 186 bar | 3,046 psi · 210 bar | +13% 574-70 (DT) |
| Three-point lift, at the coupling points declared | 6,393 lb · 2,900 kg | 6,393 lb · 2,900 kg | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,832 lb · 3,099 kg | 4,718 lb · 2,140 kg | +45% 4210 (DT) |
| Maximum permissible mass declared | — | 10,141 lb · 4,600 kg | — |
| Wheelbase declared | 88.7 in · 2,253 mm | 82.9 in · 2,105 mm | +7% 4210 (DT) |
| Length declared | 148.0 in · 3,759 mm | 128.7 in · 3,270 mm | +15% 4210 (DT) |
| Width declared | 73.0–92.7 in · 1,854–2,354 mm | 70.1–85.8 in · 1,780–2,180 mm | differs |
| Ground clearance declared | — | 17.5 in · 445 mm | — |
| Fuel tank declared | 118.3 qt · 112.0 L | 61.3 qt · 58.0 L | +93% 4210 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 4210 (DT) sources
- Source: Traktorenlexikon, “Case-IH 4210”
Lamborghini 574-70 (DT) sources
- Source: Traktorenlexikon, “Lamborghini 574-70 DT A Crono”
- Source: Traktorenlexikon, “SAME Argon 70”