Case-IH MXU 110 or John Deere 7510?
Which should you choose?
On performance, every comparable figure that differs favours the John Deere 7510: power at the PTO shaft and hydraulic flow.
- The John Deere 7510 suits PTO-driven implements (mowers, balers, pumps) better on this data: 13% (9.6 kW / 12.9 hp) more power at the PTO shaft.
- The John Deere 7510 suits loader and hydraulic implement work better on this data: 21% (17.8 L/min / 4.7 gpm) more hydraulic flow.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | MXU 110 | 7510 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 76.2 kW (102.2 hp)OECD Test 2240Measured 7% above its own claimed PTO figure (80.0 kW (107.3 hp), Traktorenlexikon, “Case-IH MXU110”). | 85.8 kW (115.1 hp)OECD Test 1959 | AheadThe John Deere 7510 has 13% more power at the PTO (9.6 kW / 12.9 hp) than the Case-IH MXU 110 (both power at the PTO, measured by a laboratory at rated engine speed). |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the MXU 110 and the 7510. |
| Which pulls harder at the drawbar? | 73.0 kW (97.9 hp)OECD Test 2240 | 79.1 kW (106.1 hp)OECD Test 1959 | EvenEven on drawbar power (both drawbar power, measured by a laboratory at maximum power): the difference is under the 10% threshold, too small to call. |
| Which pumps more oil for implements? | 83.3 L/min (22.0 gpm)Traktorenlexikon, “Case-IH MXU110” | 101.1 L/min (26.7 gpm)Traktorenlexikon, “John Deere 7510” | AheadThe John Deere 7510 has 21% more hydraulic flow (17.8 L/min / 4.7 gpm) than the Case-IH MXU 110 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | — | — | No figureNo call on three-point lift: no figure on record for the MXU 110 and the 7510. |
| Which is heavier, for traction? | 5,188 kg (11,438 lb)Traktorenlexikon, “Case-IH MXU110” | 5,864 kg (12,928 lb) to 6,028 kg (13,289 lb), varies by configurationTraktorenlexikon, “John Deere 7510” | Ahead (a fact, not an advantage)The John Deere 7510 is 13% heavier (676 kg / 1,490 lb) than the Case-IH MXU 110 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 7,500 kg (16,535 lb)Traktorenlexikon, “Case-IH MXU110” | — | No figureNo call on maximum permissible mass: no figure on record for the 7510. |
| Which has the wider choice of gears? | 16 to 24Traktorenlexikon, “Case-IH MXU110” | 16OECD test report 1959, 2001 | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the MXU 110 and the 7510. |
| Which is faster on the road? | 40 km/h (24.9 mph) to 50 km/h (31.1 mph)Traktorenlexikon, “Case-IH MXU110” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “John Deere 7510” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540E/540/1000 rpmTraktorenlexikon, “Case-IH MXU110” | 540/1000 rpmOECD test report 1959, 2001 | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Case-IH MXU110” | — | No figureNo call on PTO independence: not stated for the 7510. |
| Which drives on both axles? | 4WDOECD test report 2240, 2005; OECD test report 2245, 2005; Traktorenlexikon, “Case-IH MXU110” | 4WDOECD test report 1959, 2001; Traktorenlexikon, “John Deere 7510” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 2004–2006 | 1999–2002 | Ahead (a fact, not an advantage)The Case-IH MXU 110 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The John Deere 7510 has 13% more power at the PTO (9.6 kW / 12.9 hp) than the Case-IH MXU 110 (both power at the PTO, measured by a laboratory at rated engine speed).
- The John Deere 7510 has 21% more hydraulic flow (17.8 L/min / 4.7 gpm) than the Case-IH MXU 110 (both pump flow, as stated by the source).
- The John Deere 7510 is 13% heavier (676 kg / 1,490 lb) than the Case-IH MXU 110 (both unladen weight, as stated by the source).
- The Case-IH MXU 110 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
- Even on drawbar power (both drawbar power, measured by a laboratory at maximum power): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, three-point lift, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources