8 material differences · fewer than 12
Tractor oneCase-IH MX 80 C1998–2000No measured PTO figureTractor twoClaas Celtis 4362003–2008No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (28%); they were not built in overlapping years (1998–2000; 2003–2008). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | MX 80 C | Celtis 436 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 82.9 hp | 83 hp | — |
| Engine declared | PERKINS-FASTRAM 1004-40 Turbo-HR | — | — |
| Displacement declared | 3.99 L | — | — |
| Maximum torque declared | 218 lb·ft · 296 N·m | 246 lb·ft · 333 N·m | +13% Celtis 436 |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9 mph · 40 km/h | differs |
| Clutch declared | Pedal-operated wet Case-IH multi-disc driving clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 25.3 gpm · 95.6 L/min | 18.2 gpm · 69 L/min | +39% MX 80 C |
| Pressure declared | 3,408 psi · 235 bar | 2,611 psi · 180 bar | +31% MX 80 C |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,582 lb · 4,800 kg | 8,289 lb · 3,760 kg | +28% MX 80 C |
| Maximum permissible mass declared | 17,229 lb · 7,815 kg | — | — |
| Wheelbase declared | 95.4 in · 2,422 mm | 98.0 in · 2,489 mm | — |
| Length declared | 163.8 in · 4,160 mm | 152.4 in · 3,872 mm | +7% MX 80 C |
| Width declared | 96.7 in · 2,455 mm | 98.8 in · 2,510 mm | — |
| Ground clearance declared | 13.4 in · 340 mm | 16.5 in · 420 mm | +24% Celtis 436 |
| Turning radius, braked declared | 13.6 ft · 4.15 m | — | — |
| Fuel tank declared | 207.1 qt · 196.0 L | 153.2 qt · 145 L | +35% MX 80 C |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH MX 80 C sources
- Source: Traktorenlexikon, “Case-IH MX80C”
- Source: Traktorenlexikon, “Case-IH CX80”
- Source: OECD test report 1930, 2000
Claas Celtis 436 sources
- Source: Traktorenlexikon, “Claas Celtis 436”
- Source: OECD test report 2220, 2005