11 material differences · fewer than 12

Tractor oneCase-IH MX 1501998–2002142.7 hpMeasured at the PTO · OECD Test 1762Tractor twoJohn Deere 77101997–2003151.4 hpMeasured at the PTO · OECD Test 1709

Which should you choose?

Read our verdict on the MX 150 and the 7710 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

11 material differences · 4 fields identical or within 5%, which is not counted as material

Case-IH MX 150 and John Deere 7710, field by field
FieldMX 1507710Gap
Measured performance
PTO power, measured measured142.7 hp151.4 hp+6% 7710
Drawbar power, measured measured138.4 hp137.5 hp—
Engine
Engine power, claimed claimed147.9 hp——
Engine declaredCDC 6TA-590John Deere 6.081 TRW-02differs
Displacement declared5.88 L8.13 L+38% 7710
Maximum torque declared430 lb·ft · 583 N·m497 lb·ft · 674.0 N·m+16% 7710
Transmission
Top speed declared18.6–24.9 mph · 30–40 km/h18.6–31.1 mph · 30–50 km/hdiffers
Clutch declaredintegrated wet Case-IH multi-disc driving clutch——
Hydraulics & hitch
Hydraulic centre declaredClosed centreClosed centre—
Hydraulic control declared—Load sensing—
Pump flow declared—26.8 gpm · 101.4 L/min—
Rear PTO speeds declared540/1000 rpm540/1000 rpm—
Weight & dimensions
Unladen weight declared16,248 lb · 7,370 kg13,278–15,448 lb · 6,023–7,007 kgdiffers
Maximum permissible mass declared27,558 lb · 12,500 kg25,353 lb · 11,500 kg+9% MX 150
Wheelbase declared112.2 in · 2,850 mm110.2–114.2 in · 2,800–2,900 mm—
Length declared199.2 in · 5,060 mm187.2 in · 4,755 mm+6% MX 150
Width declared98.4 in · 2,500 mm108.3 in · 2,750 mm+10% 7710
Ground clearance declared22.0 in · 560 mm20.3 in · 515 mm+9% MX 150
Turning radius, braked declared19.3 ft · 5.87 m——
Fuel tank declared366.7 qt · 347.0 L285.9 qt · 270.6 L+28% MX 150

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Case-IH MX 150 sources

Source
  • Source: OECD test report 1762, 1998
  • Source: Traktorenlexikon, “Case-IH MX150”

John Deere 7710 sources

Source
  • Source: OECD test report 1709, 1997
  • Source: Traktorenlexikon, “John Deere 7810”
  • Source: Traktorenlexikon, “John Deere 7710”