Case-IH CX 100 or John Deere 7200 (A)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the CX 100 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 7200 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The John Deere 7200 (A) suits loader and hydraulic implement work better on this data: 63% (38.4 L/min / 10.1 gpm) more hydraulic flow.
- The John Deere 7200 (A) suits road haulage better on this data: 50% (3,000 kg / 6,614 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | CX 100 | 7200 (A) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 75 kW (101 hp)Traktorenlexikon, “Case-IH CX100” | 75.1 kW (100.7 hp)Traktorenlexikon, “John Deere 7200” | Not comparableNot comparable on power at the PTO shaft: the CX 100 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 7200 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the CX 100 and the 7200 (A). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the CX 100 and the 7200 (A). |
| Which pumps more oil for implements? | 60.8 L/min (16.1 gpm)Traktorenlexikon, “Case-IH CX100” | 99.2 L/min (26.2 gpm)Traktorenlexikon, “John Deere 7200” | AheadThe John Deere 7200 (A) has 63% more hydraulic flow (38.4 L/min / 10.1 gpm) than the Case-IH CX 100 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 3,835 kg (8,455 lb)Traktorenlexikon, “Case-IH CX100” | — | No figureNo call on three-point lift: no figure on record for the 7200 (A). |
| Which is heavier, for traction? | 4,235 kg (9,337 lb)Traktorenlexikon, “Case-IH CX100” | 5,751 kg (12,679 lb)Traktorenlexikon, “John Deere 7200” | Ahead (a fact, not an advantage)The John Deere 7200 (A) is 36% heavier (1,516 kg / 3,342 lb) than the Case-IH CX 100 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 6,000 kg (13,228 lb)Traktorenlexikon, “Case-IH CX100” | 9,000 kg (19,842 lb)Traktorenlexikon, “John Deere 7200” | AheadThe John Deere 7200 (A) has 50% higher maximum permissible mass (3,000 kg / 6,614 lb) than the Case-IH CX 100 (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 8 to 24Traktorenlexikon, “Case-IH CX100” | 12 to 16Traktorenlexikon, “John Deere 7200” | Sources disagreeNo call on forward gears: sources disagree on the figure for the CX 100. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the CX 100 and the 7200 (A). |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Case-IH CX100” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “John Deere 7200” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Case-IH CX100” | 540/1000 rpmTraktorenlexikon, “John Deere 7200” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Case-IH CX100” | independentTraktorenlexikon, “John Deere 7200” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Case-IH CX100”; OECD test report 1899, 2000 | Two-wheel or four-wheel driveTraktorenlexikon, “John Deere 7200” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1998–2000 | 1993–1997 | Ahead (a fact, not an advantage)The Case-IH CX 100 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The John Deere 7200 (A) has 63% more hydraulic flow (38.4 L/min / 10.1 gpm) than the Case-IH CX 100 (both pump flow, as stated by the source).
- The John Deere 7200 (A) is 36% heavier (1,516 kg / 3,342 lb) than the Case-IH CX 100 (both unladen weight, as stated by the source).
- The John Deere 7200 (A) has 50% higher maximum permissible mass (3,000 kg / 6,614 lb) than the Case-IH CX 100 (both maximum permissible mass, as stated by the source).
- The Case-IH CX 100 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the CX 100 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 7200 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No call on forward gears: sources disagree on the figure for the CX 100.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift and a creeper range.
← Every figure for both machines, side by side, with sources