10 material differences · fewer than 12
Tractor oneCase-IH C-48 (A)1995–1996No measured PTO figureTractor twoCase-Steyr M 948 (a)1996–2001No measured PTO figure
Which should you choose?
Read our verdict on the C-48 (A) and the M 948 (a) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | C-48 (A) | M 948 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47.3 hp | 47.3 hp | — |
| Engine declared | Steyr WD 308.85 | PERKINS 903-27 | differs |
| Displacement declared | 2.36 L | 2.70 L | +15% M 948 (a) |
| Maximum torque declared | 108 lb·ft · 147 N·m | 155 lb·ft · 210 N·m | +43% M 948 (a) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Dry Valeo double clutch type DL-2 | Dry Carraro double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 7.8 gpm · 29.4 L/min | 8.1 gpm · 30.8 L/min | — |
| Pressure declared | 3,553 psi · 245 bar | 3,481 psi · 240 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,093 lb · 2,310 kg | 5,203 lb · 2,360 kg | — |
| Maximum permissible mass declared | 7,716 lb · 3,500 kg | 9,259 lb · 4,200 kg | +20% M 948 (a) |
| Wheelbase declared | 77.5 in · 1,968 mm | 83.3 in · 2,117 mm | +8% M 948 (a) |
| Length declared | 129.5 in · 3,290 mm | 139.0 in · 3,530 mm | +7% M 948 (a) |
| Width declared | 68.5 in · 1,740 mm | 74.4 in · 1,890 mm | +9% M 948 (a) |
| Ground clearance declared | 17.5 in · 445 mm | 16.1 in · 410 mm | +9% C-48 (A) |
| Turning radius, braked declared | 10.5 ft · 3.19 m | — | — |
| Fuel tank declared | 56.0 qt · 53.0 L | 77.1 qt · 73.0 L | +38% M 948 (a) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH C-48 (A) sources
- Source: Traktorenlexikon, “Case-IH C48”
- Source: Traktorenlexikon, “Steyr 948”
Case-Steyr M 948 (a) sources
- Source: Traktorenlexikon, “Steyr M 948”