10 material differences · fewer than 12
Tractor oneCase-IH 92601990–1994No measured PTO figureTractor twoJ.I. Case 48941984–1985No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1990–1994; 1984–1985). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 9260 | 4894 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 296.0 hp | 296.0 hp | — |
| Engine declared | CUMMINS LTA-10 | SAAB-SCANIA 11-L | differs |
| Displacement declared | 10.01 L | 8.26 L | +21% 9260 |
| Maximum torque declared | 984 lb·ft · 1,334 N·m | 845 lb·ft · 1,146 N·m | +16% 9260 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Oil-immersed multi-disc clutch | Hydraulically operated wet disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 28.0 gpm · 106.0 L/min | 24.0 gpm · 90.8 L/min | +17% 9260 |
| Pressure declared | 2,306 psi · 159 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 30,135 lb · 13,669 kg | 25,750 lb · 11,680 kg | +17% 9260 |
| Wheelbase declared | 124.0 in · 3,150 mm | 110.0 in · 2,794 mm | +13% 9260 |
| Length declared | 259.1 in · 6,580 mm | 243.0 in · 6,172 mm | +7% 9260 |
| Width declared | 104.8–162.0 in · 2,661–4,115 mm | 99.0 in · 2,515 mm | differs |
| Ground clearance declared | 15.8 in · 402 mm | 18.0 in · 457 mm | +14% 4894 |
| Fuel tank declared | 799.9 qt · 757.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 9260 sources
- Source: Traktorenlexikon, “Case-IH 9260”
- Source: Traktorenlexikon, “Case-IH 9250”
J.I. Case 4894 sources
- Source: Traktorenlexikon, “Case 4894”
- Source: Traktorenlexikon, “Case 4890”