5 material differences · fewer than 12
Tractor oneCase-IH 92601990–1994No measured PTO figureTractor twoClaas Xerion 33002004–2013No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (34%); they were not built in overlapping years (1990–1994; 2004–2013). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 9260 | Xerion 3300 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 296.0 hp | 300 hp | — |
| Engine declared | CUMMINS LTA-10 | — | — |
| Displacement declared | 10.01 L | — | — |
| Maximum torque declared | 984 lb·ft · 1,334 N·m | 1,106 lb·ft · 1,500 N·m | +12% Xerion 3300 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 31.1 mph · 50 km/h | +67% Xerion 3300 |
| Clutch declared | Oil-immersed multi-disc clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 28.0 gpm · 106.0 L/min | — | — |
| Pressure declared | 2,306 psi · 159 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 30,135 lb · 13,669 kg | 22,487 lb · 10,200 kg | +34% 9260 |
| Wheelbase declared | 124.0 in · 3,150 mm | 129.9 in · 3,300 mm | — |
| Length declared | 259.1 in · 6,580 mm | 261.0 in · 6,630 mm | — |
| Width declared | 104.8–162.0 in · 2,661–4,115 mm | 98.0 in · 2,490 mm | differs |
| Ground clearance declared | 15.8 in · 402 mm | 18.5–22.4 in · 470–570 mm | differs |
| Fuel tank declared | 799.9 qt · 757.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 9260 sources
- Source: Traktorenlexikon, “Case-IH 9260”
- Source: Traktorenlexikon, “Case-IH 9250”
Claas Xerion 3300 sources
- Source: Traktorenlexikon, “Claas Xerion 3300”